Installation Guide

Operation
Installation
Part Description
Connector’s locking tab [preassembled to track head (A)]
B
A
Track head
TOOLS REQUIRED
Safety Information
Warranty
PACKAGE CONTENTS
Pre-Installation
Pre-Installation
Quantity
1
1
IMPORTANT SAFETY INSTRUCTIONS
(Save These Instructions)
USE AND CARE GUIDE
LED LINEAR TRACK HEAD
THANK YOU
Troubleshooting
Care and Cleaning
Ladder Gloves
□
removing the fuse at the fuse box.
□
□
CAUTION: Do not use chemical solvents or harsh
may occur.
Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the
Problem Possible Cause Solution
The power is off.
Make sure the power supply is on.
There is a faulty wire
connection.
Check the wiring.
Contact a quali
ed and licensed
electrician if you are not comfortable
troubleshooting wiring problems.
There is a faulty switch.
Test or replace the switch.
WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED INCLUDING THE FOLLOWING:
Installing the track head to the track
Push the top portion of the track head (A) connector into the slot of the track section.
Pull down the connector’s locking tab (B).
Twist the ground side of the track head (A) connector toward the ground side of the track section
until the track head (A) connector snaps into place.
NOTE: The ground side of the track head (A) connector is the side with two metal tabs. The
ground side of the track section has an indented groove on the face and two internal copper
strips. The track head (A) can only be assembled if the ground sides of the track head (A)
connector and the track section are aligned.
□
Identify the ground side on the track head (A) connector and track section (sold separately).
□
□
□
Removing the track head from the track
Pull down on the track head connector’s locking tab (B), and twist until the track head (A) disengages.
□
□
□
□
□
□
□
□
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
The light will not illuminate.
Hampton Bay throght the purchase of this LED linear
track head.
We strive to continually create quality products designed to enhance your home. Visit us online to see
our full line of products available for your home improvement needs. Thank you for choosing
Hampton Bay!
B
A
B
Ground tab
Ground groove
Ground side of connector
Track (sold separately)
A
B
A
CAUTION: Keep the lamp away from
materials that may burn.
WARNING: Do not install this lighting
system in a damp or wet location.
□
All electrical connections must be in accordance
with local codes and the National Electrical Code.
If you are unfamiliar with methods of installing
licensed electrician.
IMPORTANT: For use with Hampton Bay
EC series line voltage track system only.
CAUTION: The LEDs in this product
are not replaceable.
□
□
□
Do not install any part of this system less than
Do not install any lamps closer than 6 in. from
any curtain or similar combustible material.
Read all installation instructions. Save these
instructions and refer to them when additions to
Note: Some fixture shapes may vary, not shown for all models but the same assembly method.
compliance could void the user’s authority to operate the equipment.
5-YEAR LIMITED WARRANTY
or workmanship, the product must be returned, with a copy of the bill of sale as proof of purchase, to the
original place of purchase. The manufacturer will, at its option, repair, replace, or refund the purchase
becoming damaged due to misuse, accidental damage, improper handling and/or installation, and
exclusions or limitations on an implied warranty, so the above exclusions and limitations may not apply.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
7 a.m. - 6 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST Saturday
1-855-HD-HAMPTON
Questions, problems, missing parts? Before returning to store,
HAMPTONBAY. COM
Retain this manual for future use.
call Hampton Bay Customer Service
Model #DC4856BK-A, DC4856WH-A
DC9557BK-B, DC9557WH-B
DC9997BK, DC9997WH
DC11001BK, DC11001WH, DC11001SBA
Item #1002638555(804099), 1002638453(804059)
1002637590(803939), 1002637588(803899)
1002638422(804019), 1002638025(803979)
1002636976(803839), 1002636948(803819), 1002637587(803859)