Full Product Manual

Assembly Instructions

Installing the wall mounting bracket to wall

□ Determine the approximate position of where you want the fan to

be located on the wall. Then, locate the stud in the wall. Position

the wall mounting bracket (C) on wood stud or wood post and

mark the location of the four holes using a pencil or a marker (not

included).

□ Use 3/32-in. drill bit (not included) to drill pilot holes at marked

locations. Then, install wall mounting bracket (C) to the wall using

the wood screws (GG) and washers (HH).

CAUTION: If you are going to attach the fan assembly (A) to

a wood stud or wood post, the stud or wood post must be

wide enough and thick enough to sustain the wall mounting

bracket (C) and the weight of the fan assembly (A).

WARNING: To reduce the risk of the fan falling, use all

four mounting holes in the wall mounting bracket (C)

when installing.

WARNING: It is very important that you use the proper

hardware when installing the wall mounting bracket (C)

as this will support the fan assembly (A).

Installing the mounting pipe and

base assembly

□ Put one end of the pipe (B) into the slot in the base of the mounting

bracket (C).

□ Carefully insert the position knob and tighten it to hold the pipe (B).

7 feet

minimum