HIGH VELOCITY AIR CIRCULATOR MODELS: HVW-24M HVW-30M INSTRUCTION MANUAL INDOOR/OUTDOOR READ&SAVE THESE INSTRUCTIONS
HIGH VELOCITY WALL MOUNT FAN ASSEMBLY AND OPERATION INSTRUCTIONS CAUTION: Read and follow all instructions before operating fan. Do not use if any part is damaged or missing. WARNING: To reduce the risk of fire or electrical shock, DO NOT use this fan with any solid state speed control device. This appliance has a 3-prong grounded plug that must be inserted into a matching outlet. To reduce the risk of electrical shock, this grounding plug must not be cut off the plug.
If mounting on a concrete wall, be sure to locate a structurally solid and secure location to hold the weight of the fan assembly and use suitable concrete anchors (not provided ) to mount the base to the wall. MOUNTING PIPE &BASE ASSEMBLY 1. Put one end of the pipe (4) into the slot in the base. 2. Carefully insert the position knob (2) and tighten it to hold the pipe. WALL MOUNT BRACKET/ MOTOR ASSEMBLY 1. Remove the 2 bolts (9), washers (6) and nuts (5) from the wall mount pipe(4). 2.
2. Carefully slide the rear grille (15) over the bolts. 3. Secure with the flat washers, spring washers and nuts removed in Step 1. 4. Carefully slide the blade assembly (16) over the shaft and align the inner hex head driver (18) provided with the slot on the shaft of the motor. 5. Tighten the blade assembly (16) with the screws by a Philips-head screwdriver (not provided). CAUTION: DO NOT ALTER THE ANGLE OF THE BLADES. FRONT GRILLE ASSEMBLY 1.
