Use and Care Manual

If mounting on a concrete wall, be sure to locate a structurally solid and secure location to

hold the weight of the fan assembly and use suitable concrete anchors (not provided ) to

mount the base to the wall.

MOUNTING PIPE &BASE ASSEMBLY

1. Put one end of the pipe (4) into the slot in the base.

2. Carefully insert the position knob (2) and tighten it to hold the pipe.

WALL MOUNT BRACKET/ MOTOR ASSEMBLY

1. Remove the 2 bolts (9), washers (6) and nuts (5) from the wall mount pipe(4).

2. Align the holes on the pipe with the holes in the motor flange on the motor assembly.

3. Insert the bolts (9) and replace the washers and nuts removed in step 1.

4. Adjust the tilt to the desired position and tighten the pivot knob (8) to set the angle.

5. Tighten the position bolt and nut.

CAUTION: BE SURE TO SECURE THE KNOB.

MOTOR / REAR GRILLE & BALDE ASSEMBLY

1. Removed the 4 nuts, spring washers and flat washers (12,13,14) from the bolts

around the motor shaft.