Use and Care Manual

2. Carefully slide the rear grille (15) over the bolts.
3. Secure with the flat washers, spring washers and nuts removed in Step 1.
4. Carefully slide the blade assembly (16) over the shaft and align the inner hex head
driver (18) provided with the slot on the shaft of the motor.
5. Tighten the blade assembly (16) with the screws by a Philips-head screwdriver (not
provided).
CAUTION: DO NOT ALTER THE ANGLE OF THE BLADES.
FRONT GRILLE ASSEMBLY
1. Hang front grille (19) on top rib of rear grille (15) by utilizing the hook.
2. Snap the front grille into the rear grille to secure.
OPERATION INSTRUCTIONS:
1. Change the setting on the speed control to the desired operating speed. The pull
chain controls the fan speed as follows: 1 pull –Low ,2 pulls-Medium,3 pulls-High
and 4 pulls-Off.
2. To change the tilting angle of the Fan Head, Loosen the Tilt Adjustment Knob on the
fan head joint, tilt the Fan Head to the desired angle and tighten pivot knob.
3. To make the fan oscillate, pull up on the oscillating knob located on the bottom of the
motor housing. To stop the fan from oscillating, push down on the oscillating knob.
CLEANING
WARNING: Unplug fr
om electrical supply source before cleaning. After servicing, any
safety device (including grills and blades) must be reinstalled or remounted as previously
installed.
Use soft damp cloth then wipe with dry cloth .Do not use harmful cleaners. Do not bend
the blades.
.
JDVWM