Instructions / Assembly

Assembly (continued)

Locate the L Corner Brace (O) and Top Corner Extension

(P) and set out face down on a scratch-free surface.

Insert Bolts (AA) through the holes in the Plastic

Connector (JJ) and tighten.

Attach the completed assembly from step 14 into

place at the back of the mantel.

Insert Wood Dowel (CC) into the holes in the back of the

Top Mantel (G).

Use a Phillips Head Screwdriver to tighten Bolts (AA)

through the Plastic Connectors (JJ and KK).

Installing the L corner brace

Installing the top corner extension

CAUTION:

Cold climate installation recommendation: When installing this unit against a non-insulated exterior wall or chase, it is

mandatory that the outer walls be insulated to conform to applicable insulation codes.

CAUTION:

A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the replace will be on a dedicated

circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The

unit comes standard with 6-ft. three-wire cord, exiting from the rear of the replace. Avoid using an extension cord. If an extension cord must

be used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less than 1875 watts. Do not use an

extension cord more than 20 ft. in length.