Installation Guide

Assembly

Assembling the frame

□ Turn the frame (B) on its back. Insert an axle rod (F)

through the axle bushing on the frame (B). Repeat for the

second axle rod (F).

Attaching the tires

□ Place a tire (C) over the axle. Place the axle washer (II) over

the thread, screw on the axle nut (JJ) and tighten securely.

Repeat for each remaining tire.

□ Set the assembly upright on the tires.

Assembling the galvanized tee

□ Insert the brass swivel (EE) through the sleeve (AA) and

screw the end of the swivel into the galvanized tee (FF).

Using a wrench, tighten the swivel (EE) into the galvanized

tee (FF). Tighten securely but do not overtighten. Over

tightening the swivel could cause leakage.

□ Screw the galvanized tee (FF) assembly onto the spool end

(A) and tighten with a wrench.

Positioning the spool on the frame

□ Position the spool (A) on the frame so that the galvanized

tee assembly (FF) is on the side of the assembly intended

for the U-handle (D).