Installation Guide

8
Assembly (continued)
8
Attaching the leader hose
□ Attach the leader hose (E) to the end of the swivel (EE).
DO NOT OVERTIGHTEN.
E
EE
9
Attaching your garden hose
□ This cart is designed to hold up to 250 ft. of 5/8 in.
garden hose. Attach your hose to the brass adapter (on
the galvanized tee). Loop the hose over the spool end (as
shown) to avoid kinking.
Maintenance
ROUTINE MAINTENANCE
□ To help delay rust, check for any scratches on your hose cart.
Apply clear acrylic/weatherproof paint to avoid rusting.
□ Drain water before storing.
□ DO NOT leave water running through the reel while not in use
or unsupervised.
□ Turn off water after each use.
FIXING A LEAKING SWIVEL
It is normal for the swivel to leak slightly until the O-rings are wet
and have seated. If the leaking continues, you do not need to take
the cart back to the store. This is a simple problem and is easily
xed by a simple procedure:
1. If the leader hose is attached to the swivel, unscrew the hose
and look inside the swivel.
2. Using either a hex key or a large screw driver, insert the tool
into the hex opening and gently tighten the threaded insert to
stop the leaking. DO NOT OVER TIGHTEN!
3. If the unit still leaks, check that the hose washer is inside the
nut. You may contact customer service for a new hose washer
or obtain one at any hardware store.
4. If your swivel is old, the O-rings may be worn. Contact
customer service for a new set of O-rings.
5. If these steps do not solve your leaking problem, then contact
customer service at 1-855-HD-HAMPTON.
SHAFT
O-RING HOUSING O-RING
SNAP RING
WASHER
INSERT
O-RING
NUT