Warranty

2
Care & Cleaning
Troubleshooting
Warranty
□ Clean the solar panel with a damp cloth. Do not use any chemicals or abrasives.
Problem Solution
The nightly runtime for the lights is shorter. □ The battery is not adequately charged. Locate the solar light in an area where it can receive the
maximum amount of full, direct sunlight every day.
□ The batteries are reaching the end of their useful life. Replace the old batteries with new batteries.
The lights do not turn on in the evening. □ The solar panel is installed close to other light sources. Relocate the solar panel or eliminate the other
light sources.
The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only
to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation,
and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through
misuse, abuse, accident, modications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly
installed, set up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a
result of an accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty workmanship. This warranty shall not apply
to the nish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specically disclaims any warranty, whether expressed or implied, or tness for a particular purpose, other than the warranty contained herein. The manufacturer
specically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the
replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
Assembly and Installation (continued)
NOTE: Each spotlight has a top wire (1) and a bottom wire (2).
Connecting the spotlights
Connecting the spotlights to the solar
panel
□ Connect the spotlights in a series by screwing the bottom
wire (2) clockwise into the top wire (1) of the next light.
□ Connect the last spotlight in the series to the solar panel (E) by
screwing the bottom wire (1) clockwise into the outlet plug on the
underside of the solar panel (2).
4 5
NOTE: Do not use a hammer. If the ground is hard, use water to soften
or a trowel to loosen the soil.
NOTE: Ensure the wire at the bottom of the spotlight head ts into the
notch (AA) at the bottom of the spotlight head post to avoid pinching
the wire.
Installing the spotlight into the ground
(Option 1)
□ Attach the spotlight head (A) rmly to the stake (D).
□ Push the spotlight assembly rmly into the ground.
3a
NOTE: Make sure the wire at the bottom of the spotlight head ts
into the notch (AA) at the bottom of the spotlight head post to avoid
pinching the wire.
Installing on a wooden post (Option 2)
□ Mount the xer (B) to the post using the screws provided (C).
□ Attach the spotlight head (A) rmly to the xer (B).
3b
A
C
AA
B
A
AA
D
2
1
E
2
1
Option 1 Option 2