Installation Guide

5
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Installation
1
Making the electrical connections
Installing the mounting bracket
EE
DD
BB
Insert long machine screws (EE) into the mounting
bracket (DD).
Connect the mounting bracket (DD) to the outlet
box with short machine screws (BB).
Orient the mounting bracket (DD) so the raised
center portion protrudes into the outlet box.
Wrap the ground wire from the outlet box around
the ground screw on the mounting bracket (DD)
no less than 2 in. from the end of the wire.
If the xture is supplied with a ground wire,
connect it to the outlet ground wire with a wire
connector (AA).
Make the wiring connections using the wire
connectors (AA) according to the diagram.
2
DANGER: Hazardous voltages cause severe injury or death.
Disconnect all sources of power before servicing.
NOTE: For installation in Canada, if the
xture is supplied with a ground wire, wrap it
around the ground screw on the mounting
bracket (DD), and tighten the ground screw.
NOTE: When parallel wire (SPT I & SPT II)
is used, the neutral wire is square
shaped and ridged and the hot wire will
be round in shape and smooth.
BARE COPPER, OR
GREEN GROUND
SUPPLY WIRE
BARE COPPER, OR
GREEN GROUND
FIXTURE WIRE
BLACK FIXTURE
WIRE
OR
WHITE FIXTURE
WIRE
BLACK SUPPLY
WIRE
BLACK SUPPLY
WIRE
PARALLEL FIXTURE CORD
(ROUND AND SMOOTH)
PARALLEL FIXTURE CORD
(“D” SHAPED AND RIDGED)
WHITE SUPPLY
WIRE
WHITE SUPPLY
WIRE