Instructions / Assembly

7 HAMPTONBAY.com
Please contact 1-855-HD-HAMPTON for further assistance.
Shade Installation
1
Installing the bulb and shade
□ Install the light bulb included (C). Do not over
tighten. Use 9 watt LED maximum medium
base light bulb.
□ Attach the shade (B) to the light kit (A) shade
(BB). To avoid breakage, do not over tighten.
□ Restore electrical power. Installation is complete.
Installing a Fitter
color, complete these steps:
1.
loosen the hex nut (1) and bushing (2) to release
2.
washer (4) over the threaded tube (5), then
tighten with the hex nut (1).
4. Take the switch (6) through the side hole of the
NOTE:
Troubleshooting
Problem Solution
The light will not turn on. □ Make sure the power supply is on.
□ Test or replace the switch.
□ Turn off electricity and remove either the canopy
or decorative housing on your ceiling fan to make
sure the blue or red wire from the ceiling fan is
connected to the black wire from the light kit.
The fuse blows or the circuit breaker trips when the
light is turned on.
□ Check the wire connections.
holders by finger tightening the shade screws
If you want to replace the fitter for the fan light kit,
If you wish to change your fitter based on your fan
the fitter (3).
When re-installing, place the fitter (3) and star
fitter then tighten with the bushing (2).
BB
In case the light pull chain is short at your location,
please attach the pull chain extensions (CC) to the
light pull chain.