Installation Guide

ManualsBrandsHampton Bay ManualsLandscape LightingSolar 15 Lumens Black Outdoor Integrated LED Shepherd Hook Path Light (2-Pack); Weather/Water/Rust Resistant

Table Of Contents

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

PACKAGE CONTENTS

PLANNING FOR A SUCCESSFUL ASSEMBLY

□ Read all instructions before assembly and installation.

□ Inspect each part for defects that may have occurred during shipping.

□ Keep your receipt and these instructions for proof of purchase.

CHOOSING THE RIGHT LOCATION

Install your solar light in a location with full, direct sunlight. Do not install in shaded areas as these areas will not allow the batteries to fully charge and will reduce

the nighttime operating hours for your light. Ensure that the installation location is away from other nighttime light sources such as street or porch lamps. These light

sources may prevent your solar light from automatically turning on.

HOW SOLAR WORKS

The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the

solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and

season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.

Assembly and Installation

Preparing for installation

Item #1006 683 616

Model #93153

NOTE: Do not use a hammer. If the ground is hard, use

water to soften it or a trowel to loosen the soil.

Installing the solar light in the ground

□ Push the assembly rmly into the ground.

□ Attach the assembly light head on the hook (F).

Use and Care Guide

Solar LED Path Light

A - Top cover

x 2

□ FOR FIRST TIME USE: Twist and

remove the top cover (A) from the

housing (B). Slide the switch to the

ON position.

□ Replace the top cover (A) on the

housing (B).

□ Twist the post (G) into the hook (F)

then twist the second post into the

ﬁrst post (G).

□ Firmly push the assembly hook

into the stake (H).

NOTE: The solar panel will turn

the light on automatically at

dusk.

B - Housing

x 2

C - Bulb

(pre-installed)

x 2

D - Battery cover

x 2

E - AA 1.2V 1000mAh

Ni-Mh rechargable battery

(pre-installed) x 2

F - Hook

x 2

G - Post

x 4

H - Stake

x 2

BA G HC D E F

Summary of content (4 pages)

PAGE 1
Item #1006 683 616 Model #93153 Use and Care Guide Solar LED Path Light PACKAGE CONTENTS A B A - Top cover B - Housing x2 x2 C D E F C - Bulb D - Battery cover E - AA 1.2V 1000mAh Ni-Mh rechargable battery (pre-installed) x2 (pre-installed) x 2 x2 G H F - Hook G - Post H - Stake x2 x4 x2 PLANNING FOR A SUCCESSFUL ASSEMBLY □ Read all instructions before assembly and installation. □ Inspect each part for defects that may have occurred during shipping.
PAGE 2
Maintenance Replacing the battery CAUTION: When replacing the battery, use one (1) 1000 mAh NiMH AA 1.2V rechargeable battery. B D E IMPORTANT: Dispose of the batteries in accordance with local, state, and federal regulations. NOTE: For best performance, replace with a rechargable 1.2V AA NiMH battery of 1000 mAh or greater every 3 years or when performance diminishes. A □ Twist and remove the housing (B) from top cover (A). □ Remove the battery cover (D).
PAGE 3
Artículo Núm. 1006 683 616 Modelo Núm.93153 Guía de uso y cuidado Lámpara LED solar para sendero CONTENIDO DEL PAQUETE A A - Cubierta superior x2 B B - Carcasa C C - Bombilla (preinstalada) x2 x2 D D - Tapa de la batería x2 E F E - Batería recargable AA de Ni-Mh de 1000 mAh y 1.2 V (preinstalada) x 2 G H F - Gancho G - Poste H - Estaca x2 x4 x2 PLANIFICACIÓN DEL ENSAMBLAJE EXITOSO □ Leer todas las instrucciones antes de ensamblar e instalar.
PAGE 4
Mantenimiento Cómo reemplazar la batería CUIDADO: Al reemplazar la batería, usa una (1) recargable AA de NiMH de 1000 mAh y 1.2 V. B D E IMPORTANTE: Desechar las baterías de acuerdo con las regulaciones locales, estatales y federales. NOTA: Para un mejor funcionamiento, reemplaza con una batería recargable AA de NiMH de 1000 mAh y 1.2 V cada 3 años o cuando el rendimiento disminuya. A □ Gira y retira la carcasa (B) de la cubierta superior (A). □ Retira la cubierta de la batería (D).