Full Product Manual

HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
Assembly and Installation
Item #1007 976 447
Model #99160
A - Fixture head x 1 B - Post x 1 C - Stake with foot step x 1
D - Connector with
12 in. wire length
(attached to xture) x 1
Use and Care Guide
Black Springs
LED Low Voltage Path Light
Attaching and installing the light
1
□ Detach and place the wire connector (D) on opposite sides of the
low voltage cable (not included) where the xture will be located.
(additional landscape lighting cable can be purchased at your local
Home Depot store).
□ Align and t the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (D) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact.
□ Turn on the power unit. If the light xture does not turn on, repeat the
previous 3 steps.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
□ Attach the xture head (A) to the top post (B) by inserting the upper end of
the post (B) into the xture head.
□ Insert the xture wire (2) into the groove located on the top of the ground
stake.
□ Attach the post (B) to the stake (C) by placing the bottom of the post (B)
onto the top of the stake (C) and twisting clockwise.
□ Prepare a hole in the installation location. Use a screwdriver to prepare
the installation hole to ensure that the hole is not larger than the stake (C).
□ Install the xture in the ground by pushing on the foot step (1) on the
stake (C). Do not push the xture head.
Connecting the wires
2
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
NOTE: Do not use a hammer. If the ground is hard, use
water to soften it or a trowel to loosen the soil.
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
WARNING: Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
A
B
C
D
D
A
B
D
2
1
C
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the
light, or next to a building structure such as a house or
deck.
□ Do not bury the wiring by more than 6 in. (15.24 cm) in
order to connect to the main secondary wire.
□ Do not submerge xtures in water.
□ Have the length cut off so that it is connected to a
connector within 6 inches (15.2 cm) from a building
structure, a luminaire, or tting.