Use and Care Manual

Table Of Contents

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

Hanging the fan

□ Pass the 120-Volt supply wires through the center hole in the

mounting bracket (A).

□ Install the ceiling mounting plate on the outlet box by sliding the

mounting bracket (A) over the two screws (HH) provided with the

outlet box. If necessary, use leveling washers (not included) be-

tween the mounting bracket (A) and the outlet box. Note that the

at side of the mounting bracket (A) is toward the outlet box.

□ Securely tighten the two mounting screws (HH).

□ Carefully lift the fan motor assembly (D) up to the mounting

bracket (A).

□ Seat the hanger ball portion of the ball/downrod assembly (B)

in the mounting bracket socket. Ensure that the tab on the

mounting bracket (A) socket is properly seated in the groove

in the hanger ball. If using close-to-ceiling mounting, hang the

fan on the hook provided by utilizing one of the holes at the

outer rim of the ceiling canopy.

3 4

WARNING: To reduce the risk of re, electric shock,

or other personal injury, mount the fan to an outlet

box or supporting system marked acceptable for fan

support and use the mounting screws provided with

the outlet box.

WARNING: The hook as shown is only to balance fan

while attaching wiring. Failure to hang as shown may

result in hook breaking, causing the fan to fall. Hook

must pass from inside to outside of canopy.