Instructions / Assembly

10
Installing the Light Kit
Remove 1 screw (A1) and loosen 2 screws
(A2) from the mounting ring; do not remove
the 2 screws. (See illustration)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed.
Remove 1 screw (B1) and loosen 2 screws (B2)
from the mounting ring, do not remove the 2
screws. (See illustration)
Raise and hold the light kit close to the mount-
ing plate and make the wire connections.
Connect the white wire connectors from the
light kit and fan, follow the same procedure
with the black wire connectors. (Fig. 15)
1.
2.
3.
4.
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
NOTE
Figure 15
A1
A2
B1
B2
Mounting Ring
Mounting Plate
Screws
Light Kit
Screws
Mounting Ring
Wire
connectors
5.
6.
7.
8.
9.
Carefully push all wires back into the mount-
ing plate, then install the light kit onto the
mounting ring with 3 screws provided. Be sure
to tighten all screws. (Fig. 15)
Remove the metal plate and glass cover from
the light kit.
Install 2 x 13 watt (Max.) compact fluorescent
bulbs (included)
Raise the glass shade up against the light kit,
Place the metal plate with rubber on the top
over the stem and turn it clockwise until it
locks up against the glass shade. Do not
overtighten. (Fig. 16)
Raise the glass cover against the glass shade
and secure it to the stem by turning the glass
cover clockwise until snug.