Instructions / Assembly

1111
Installing the Battery:
Install 12V MN21/A23 battery (included), to
prevent damage to transmitter, remove the battery
if not used for long periods. (Figure 18)
Operating Your Transmitter
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Bulbs
Glass Shade
Metal Plate
Glass Cover
Figure 16
The receiver frequency selector is located on
the top of the motor assembly plate as shown in
Fig. 17.
The transmitter frequency selector is located in
the battery compartment as shown in Fig.17.
Each frequency selector has 4 switches, you
may use any number of possible combinations
but you must set each switch in the transmitter
to match the same switch in the receiver.
1.
2.
Figure 17
Code Switch
Figure 18