Instructions / Assembly

4
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
Hanging the Fan
WARNING
FAILURE TO PROPERLY INSTALL COTTER
PIN AS NOTED IN STEP 6 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
Tighten two set screws at top of the fan motor
collar firmly and evenly. (Fig. 5)
Place the nut at the end of the decorative cable
wire to the screw on the top of the motor
housing. Tighten the nut to the screw. Repeat
this procedure for the remaining decorative
cable wires. Secure the coupling with setscrew
tightly. (Fig. 6)
7.
8.
Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Figure 4)
Remove the mounting bracket from the canopy
by removing the 1 of 2 screws from the
bottom of the mounting bracket and loosening
the other one a half turn from the screw head.
Next, turn the canopy counter clockwise to
removing the mounting bracket from the
canopy. (Figure 4)
Remove the clevis pin, cotter pin and set
screws from the top of the motor assembly.
(Fig.5)
Loosen the setscrew from the coupling located
at the top of the decorative cable wire
assembly.
Route wires exiting from the top of the fan
motor through the coupling cover, decorative
cable wire assembly, canopy cover, canopy
and then through the ball/downrod. (Fig. 5)
Align the holes at the bottom of the downrod
with the holes in the coupling on top of the
motor housing. (Figure 5) Carefully insert the
clevis pin through the holes in the collar and
1.
2.
3.
4.
5.
6.
downrod. Be careful not to jam the clevis pin
against the wiring inside the downrod. Insert
the cotter pin through the hole near the end of
the clevis pin until it snaps into its locked
position, as noted in the circle inset of Fig. 5.
Figure 4
Ceiling
Mounting
Bracket
Ceiling Canopy
Canopy Bottom
Cover
Figure 5
Motor Wires
Ceiling Canopy
Ball/Downrod
Assembly
Canopy Bottom
Cover
Cotter Pin
Tighten Screw
Firmly
Motor Collar
Clevis Pin
Coupling
Cover
Decorative Cable
Wire Assembly
Pin in Locked
Positioon