Instructions / Assembly

5
Changing the Downrod
(Optional)
Set Screw
Decorative
Cable
Nut
Screw
Figure 6
NOTE: Your fan comes with a 12" downrod
attached to the hanger ball. In addition you have
been provided with a 4-1/2" downrod to use if
desired. If you choose to use the 4-1/2" downrod,
perform the following steps:
Remove the hanger ball from the 12" downrod
by loosening the set screw at the top of the
downrod which holds the hanger ball to the
downrod.
Slide the hanger ball down the downrod and
remove the support pin.
Insert the support pin in the holes at the top of
the 4-1/2" downrod and slide the hanger ball up
the 4-1/2" downrod. Make sure the support pin
is properly seated in the grooves in the top of
the hanger ball.
Tighten the set screw firmly.
1.
2.
3.
4.