Instructions / Assembly

Preparing the light kit

Attaching the light kit to

the switch housing

Preparing the fan

Assembly - Installing the Light Kit

□ Remove the switch housing cover (D) from the switch

housing (C) below the fan by removing the three switch

housing mounting screws.

□ Remove the plastic plug from the switch housing cover

(D).

□ While holding the 14w LED light kit (A) under your fan motor

assembly, locate two single white and blue wires (HH) in the

switch housing labeled "FOR LIGHT". Make the polarized plug

connections:

- White to white

- Black to black

□ Carefully push all wires back into the switch housing. Install

the LED light kit (A) onto the switch housing with the three

switch housing mounting screws provided. Be sure to tighten

all screws.

□ Route the light kit wires (black and white) (GG) through the

hole of the switch housing cover (D).

□ Screw the switch housing cover onto the light kit stem and

fasten by using the lock washer (BB) and nut (AA). Be sure it is

tight enough to prevent the light kit from vibrating loose.

CAUTION: Before starting the installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.