Instructions / Assembly

Installing the glass shade

Assembly (continued)

□ Remove the glass secure nut (DD) and rubber

washer (CC) from the light kit stem and keep for later

use.

□ Place the glass shade (B) over the light kit stem and

secure with the rubber washer (CC), glass secure nut

(DD), glass cap (EE) and decorative nut (FF). Do not

overtighten.

□ Insert the two pull chains (II) through the eyelet in the

glass shade (B) and glass cap (EE).

□ Install two pull chains and fobs (JJ) (not included)

onto the pull chains located in the switch housing (C)

and 14w LED light kit (A). Turn on the power and

check the operation of the light kit.

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.