FINISHED CABINETRY I N S TA L L AT I O N GUIDE CONTENT CONTENU CONTENIDO 02 Step 1 to 5 Étapes 1 à 5 Paso 1 a 5 05 Hinges Pentures Bisagras 06 Lazy Susan 08 Warranty Garantie Garantía
INSTALLATION INSTRUCTIONS INSTRUCTIONS POUR L’INSTALLATION INSTRUCCIONES PARA LA INSTALACION Step / Étape / Paso 1 CABINET INSTALLATION. SELECT HARDWARE THAT IS BEST SUITED FOR YOUR WALL TYPE.* Important: use “pan head” or “round head” screws with seat washers. Seat screws tightly against back rail or panel without driving into back rail or panel material INSTALLATION DES ARMOIRES. CHOISISSEZ LA QUINCAILLERIE LA PLUS APPROPRIÉE POUR VOTRE TYPE DE MUR.
Step / Étape / Paso 2 CABINET INSTALLATION. STARTING IN A CORNER. Always start in a corner where two runs of cabinets will come together. All doors will need to be removed during the installation process to properly align all cabinets together. Locate and mark wall studs where planned cabinets are to be installed. Place the corner cabinet into that position. Use a level to be sure that the cabinet is level and plum. If needed, shim the cabinet to level.
Step / Étape / Paso 4 INSTALL REMAINING CABINETS Drill a 3/16” pilot hole at the stud locations through the back panel. Level and mount the cabinet to the wall with #10 x 3” screw. If needed, shim the cabinet to level. DO NOT COMPLETELY TIGHTEN MOUNTING SCREWS UNTIL ALL CABINETS HAVE BEEN ATTACHED TOGETHER. After all cabinets have been attached together and are level and secure, then tighten all mounting screws.
*The fastening solutions described here are recommendations only, and are based on commonly used installations. Each installer must evaluate the specific characteristics of the particular wall on which the cabinets are to be installed to ensure the proper fastening solution is used and the product is fastened safely and securely. This may require hardware or fastening methods which are different from, or additional to, what is described here.
LAZY SUSAN BASE CABINET INSTALLATION INSTALLATION DE L’ARMOIRE DE BAS COIN AVEC PLATEAU TOURNANT INSTALACIÓN DEL GABINETE DE BASE CON BANDEJA CIRCULAR GIRATORIA Locate and mark all stud locations. Install 2”x4” framing material as cleats to support the countertop. Use a level to ensure the cleats are level. Drill 3/16” pilot holes through the cleat. Mount the cleat to the wall with appropriate hardware for your wall type.
2 ENSURE THE CABINET IS LEVEL AND STRAIGHT. USE SHIMS IF NECESSARY. S’assurer que l’armoire est droite et au niveau. La caler au besoin. Asegúrese de que el gabinete esté nivelado y recto. Use calzas si fuera necesario. 3 DRILL TWO (2) 3/16” PILOT HOLES THROUGH THE BACK OF THE CABINET AT EACH STUD LOCATION. USE TWO (2) #10 X 2-1/2” CABINET SCREWS TO SECURE THE CABINET TO THE WALL. 3/16" Percer deux (2) trous de guidage de 3/16 po (4,8 mm) dans le fond de l’armoire à l’emplacement des montants.
WARRANTY / GARANTIE / GARANTÍA WHAT DOES THE WARRANTY COVER? - This lifetime limited warranty is valid from the date of purchase and covers all products below against defects in material and factory workmanship, providing normal use and maintenance by the purchaser: Cabinets, glass and melamine shelves, hinges, gliders and all drawer parts (excluding the soft closing drawer system).
