Instructions / Assembly

11
Attaching the Mounting
Plate
Remove 1 of the 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 20)
1.
2.
Figure 20
Mounting
Plate
Mounting
Ring
Screws
Installing the Light Kit
Install 1 x 60 Watt candelabra bulb (included).
(Fig. 21)
Raise glass shade with light frame up against
bottom of fan housing and secure with three
screws provided. (Fig. 21)
Restore power and your light kit is ready for
operation.
1.
2.
3.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
NOTE
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Figure 21
Screws
Glass Shade With
Light Frame
Bulb
Mounting Plate