Installation Guide

Installing the Mounting
Plate
Remove 1 of 3 screws from the mounting ring
and loosen the other 2 screws. (Do not remove)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
1.
2.
Installing the
Light Kit
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Remove the plug from the switch housing.
Attach the light kit to the switch housing by
feeding the light kit wires (black and white)
through the hole of switch housing and then
screw it onto the switch housing by nut & lock
washer. Be sure it is tight enough to prevent
light kit from vibrating loose. (Fig. 16)
While holding the light kit assembly under
your fan, snap together the wire connection
plugs. (Fig. 17)
Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 17)
1.
2.
3.
Figure 16
Nut
Switch
Housing
Light Kit
Lock Washer
Aditional
plastic plug
Remove the lock ring from the socket by
turning the lock ring clockwise until it unlocks.
Insert the glass into the glass holder and turn
the lock ring counter-clockwise to tighten the
glass. Repeat for the remaining glass. (Fig. 17)
Install 3 x 60 Watt candelabra bulbs (included).
Restore power and your light kit is ready for
operation.
4.
5.
6.
NOTE
IF YOU DO NOT PLAN TO INSTALL THE LIGHT
KIT WITH YOUR FAN AT THIS TIME, SKIP STEP
1-6.
Figure 15
Mounting
Ring
Screws
Mounting
Plate
10