Instructions / Assembly

Table Of Contents

9 HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Preparing the canopy

Preparing the motor

□ Remove the two non-slotted canopy mounting screws

with lock washers (BB) from the canopy (B), and

loosen the slotted canopy mounting screws with lock

washers (BB) on the canopy (B).

□ Remove the canopy (B) from the mounting bracket (A)

by turning the canopy (B) counterclockwise.

Assembling the fan

□ Route the wires through the canopy (B) and then

through the hanger ball/downrod assembly (D).

□ Align the holes at the bottom of the hanger

ball/downrod assembly (D) with the holes in the

collar on top of the fan motor assembly (E). Carefully

insert the clevis pin (DD) through the holes in the

collar and the hanger ball/downrod assembly (D). Be

careful not to jam the clevis pin (DD) against the

wiring inside the hanger ball/downrod assembly (D).

□ Insert the cotter pin (EE) through the hole near the

end of the clevis pin (DD) until it snaps into the

locked position.

□ Tighten the two collar setscrews (FF) on top of the

fan motor assembly (E) rmly.

WARNING: Failure to properly install the cotter pin (EE)

could result in the fan becoming loose and possibly falling.

NOTE: If a longer downrod is needed (not included), take out

the screw located in the hanger ball, lower the hanger ball

and remove the pin. Remove all three pieces from the

downrod, and assemble them onto the new longer downrod

before proceeding step 3.

□ Remove the cotter pin (EE), and clevis pin (DD), and

loosen the two collar setscrews (FF) from the motor

collar.

Assembly — Standard Ceiling Mounting