Instructions / Assembly

Assembly — Close-to-Ceiling Mounting

Assembling the fan

Preparing the motorPreparing the canopy

□ Remove the mounting bracket (A) from the canopy (B)

by loosening the four mounting bracket screws (BB)

on the top of the canopy (B). Remove the two

non-slotted mounting bracket screws (BB) and loosen

the slotted mounting bracket screws (BB).

□ Remove the canopy bottom cover (C) from the canopy

(B).

□ Remove three of the six collar mounting screws with

lock washers (GG) (every other one) from the collar

on top of the fan motor assembly (E).

□ Make sure the slot openings are on top, and then

proceed to place the canopy (B) over the collar at the

top of the fan motor assembly (E).

□ Align the mounting holes in the bottom of the canopy

(B) with the holes in the top of the fan motor assem-

bly (E), and fasten using the three collar mounting

screws with lock washers (GG) previously removed.

□ Tighten the collar mounting screws (GG) securely.

WARNING: Failure to completely tighten the three collar

mounting screws (GG) could result in the fan becoming loose

and possibly falling.