Instructions / Assembly

Assembly — Attaching the Fan Blades

Removing the rubber

packing mounts

□ The fan motor assembly (F) is shipped with rubber

packing mounts (XX) to prevent movement during

transportation. Remove the ﬁve rubber packing

mounts (XX) from the fan motor assembly (F) and

discard prior to attaching the blade arms.

Attaching the blades to

the blade arms

□ Hold the blade (G) with hands close to the blade arm

(H), align the key-slot holes (AAA) with the blade arm

posts (BBB) and press the blade down ﬁrmly. Ensure

the key-slot holes (AAA) are properly seated on the

blade arm posts (BBB).

□ Firmly slide the blade (G) away from the blade arm (H)

until the blade (G) engages in the spring locking

mechanism (CCC). Make sure the spring of the spring

locking mechanism (CCC) is upward and the butt of

the spring locking mechanism (CCC) is against the

edge of the blade.

NOTE: Your fan blades are reversible. Select the blade side

ﬁnish which best accentuates your decor.

To install the blade to the blade arm:

□ Press down the spring locking mechanism (CCC) to

release the blade (G) from the blade arm (H). Slide

the blade (G) toward the blade arm (H) until the blade

(G) disengages from the spring locking mechanism

(CCC). Carefully push the blade (G) up to detach from

the blade arm (H).

To detach the blade from the blade arm:

WARNING: Failure to properly seat the blades (G) on the

blade arms (H) and engage in the spring locking mechanism

(CCC) could result in the fan blades (G) loosening and possibly

falling.

CCC

AAA

BBB