Instructions / Assembly

Assembly — Standard Ceiling Mounting

Preparing the canopy

Preparing the motor

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the two non-slotted screws (BB) from the

canopy (C), and loosen the slotted screws (BB) on the

canopy (C).

□ Remove the canopy (C) from the mounting bracket

(A) by turning the canopy (C) counterclockwise.

Assembling the fan

□ Route the wires exiting from the top of the fan motor

assembly (F) through the canopy ring (B). Ensure the

slot openings are on top.

□ Route the wires through the canopy (C) and then

through the hanger ball/downrod assembly (E).

□ Align the holes at the bottom of the hanger

ball/downrod assembly (E) with the holes in the collar

on top of the fan motor assembly (F). Carefully insert

the clevis pin (CC) through the holes in the collar and

the hanger ball/downrod assembly (E). Be careful not

to jam the clevis pin (CC) against the wiring inside the

hanger ball/downrod assembly (E).

□ Insert the cotter pin (DD) through the hole near the

end of the clevis pin (CC) until it snaps into the locked

position.

□ Tighten the two collar setscrews (EE) on top of the

fan motor assembly (F) ﬁrmly.

WARNING: Failure to properly install the cotter pin (DD)

could result in the fan becoming loose and possibly falling.

NOTE: If a longer downrod is needed (not included), take

out the screw located in the hanger ball, lower the hanger

ball and remove the pin. Remove all three pieces from the

downrod, and assemble them onto the new longer downrod

before proceeding step 3.

□ Remove the clevis pin (CC), and cotter pin (DD), and

loosen the two collar setscrews (EE) from the motor

collar.

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.