Instructions / Assembly

Assembly — Close-to-Ceiling Mounting

Assembling the fan

Preparing the motorPreparing the canopy

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the two non-slotted screws (BB) from the

canopy (C), and loosen the slotted canopy mounting

screws (BB) on the canopy (C).

□ Remove the canopy bottom cover (D) from the

canopy (C).

□ Remove three of the six collar mounting screws with

lock washers (FF) (every other one) from the collar on

top of the fan motor assembly (F).

□ Route the wires exiting from the top of the fan motor

assembly (F) through the canopy ring (B).

□ Make sure the slot openings of the canopy ring (B)

are on top, and then proceed to place the canopy ring

(B) and canopy (C) over the collar at the top of the fan

motor assembly (F).

□ Align the mounting holes in the bottom of the canopy

bly (F), and fasten using the three collar mounting

screws with lock washers (FF) previously removed.

□ Tighten the collar mounting screws (FF) securely.

WARNING: Failure to completely tighten the three collar

mounting screws (FF) could result in the fan becoming loose

and possibly falling.