Instructions / Assembly

Assembly — Installing the Light Kit

Attaching the light kit to

the switch housing

□ Remove the three light kit mounting screws (HH)

from the 14W LED light kit (I) and keep these screws.

□ While holding the 14W LED light kit (I) under your fan

motor assembly (F), locate two single white and blue

wires in the switch housing labeled "FOR LIGHT".

Make the polarized plug connections:

- White to white

- Blue to black

□ Carefully push all wires back into the switch housing.

Install the light kit assembly (I) onto the switch

housing with the three light kit mounting screws (HH)

removed previously. Be sure to tighten all screws.

CAUTION: Before starting the installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

Mounting the glass shade

□ Remove the plastic nut (II), glass cap (JJ) and

decorative nut (KK) from the 14W LED light kit (I).

□ While holding the glass shade (J), slip the pull chain

(VV) from the switch housing into the outside hole in

the glass shade (J).

□ Feed the pull chain (VV) from the light kit stem

through the eyelet in the glass shade (J).

□ Place the glass shade (J) over the light kit stem.

Secure the glass shade (J) with the plastic nut (II).

□ Fit the glass cap (JJ) onto the light kit stem, and then

slip the pull chain (VV) from the side hole in the glass

shade (J) through the hole on the side of the glass

cap (JJ).

□ Feed the pull chain (VV) from the light kit stem

through the decorative nut (KK), and then thread the

decorative nut (KK) securely. Do not overtighten.