Installation Guide

22
9
10
COUNTERTOP BRACES
DEEP WALL CABINET
Wheninstallingcabinetsorllersthatleaveavoidbetweenthewallandcabinet/ller,
you must install a 1 x 3 brace to support the countertop.
Install the brace so it exactly matches the Base Cabinet Top Level Line. Pre-drill the
brace as described for base cabinets in Attachment to Wall section; Use 2-1/2"
screws and follow the Attachment Minimum Requirements section; use toggle bolts or
drywall anchors elsewhere.
The length of the countertop brace should leave approximately 1" on each end
between the brace and the cabinet.
GENERAL INFORMATION INSTALLATION REQUIREMENTSPRE-INSTALLATION INSTALLATION
WARNING: DO NOT install a deep wall cabinet independently.
Failure to follow this warning may result in the cabinet falling off the
wall, which may cause serious personal injury or property damage that
will not be covered by the product warranty. Manufacturer assumes
no responsibility for any product failure due to improper installation or
installation inconsistent with these instructions.
Both sides of the face frame must be supported through both left and
right frame stiles by another cabinet, a wall or an end ller.
Screw 23" long counter
top brace into wall studs.
Blind Corner Panel
Face Frame Center Stile
Clamp together and
screw at top and bottom.