Installation Guide

27
Beforescribing,putmaskingtapedownthellerwherethescribemarkwillbe.
Thistapewillshowthemarkbetterandwillprotectthewallllersurfacewhencutting.
Usetheprotractorcompasstoscribethewallcontourontothewallller.
Cutthewallller,followingthescribemark.Putthellerinposition.Fastentheller
to the cabinet frame using the Frame-to-Frame Attachment section requirements. Use
nishingnailstotackthewallllertothebackerboard,ifnecessary.
GENERAL INFORMATION INSTALLATION REQUIREMENTSPRE-INSTALLATION INSTALLATION
WALL FILLER; BASE, WALL (CONTINUED)
Transfer Width to Filler
Masking Tape
Filler Width
Transfer Wall Contour
to Filler Wall Strip
Backer Board
Compass