Instructions / Assembly

30 | Installation How-Tos Installation How-Tos | 31
Tall End Filler & 24" Deep Wall Cabinet
Installation
The Tall End Filler conceals the side of a refrigerator and
supports a 24" Deep Wall Cabinet above. Tall End Fillers are
shipped without a Toespace Cutout and must be inverted
for left- or right- hand use before marking and cutting the
Toespace.
Determine whether the application is Left- or Right- Hand.
Measure the Toekick height and depth from an adjacent Base
Cabinet and transfer these dimensions to the proper end of
the Tall End Filler. Follow dimensions to cut out the Toespace.
Put Tall End Filler in place. Align the top of the Tall End Filler
either to the Wall Cabinet Top Level Line or to the top of an
adjacent Wall Cabinet.
If needed, shim the Tall End Filler so the Face Frame is plumb
and lined up with the bottom of the Base Cabinet. Attach the
Filler to the adjacent cabinet according to the Frame-to-
Frame Attachment requirements.
Use angle brackets or Backer Board (not provided) to attach
the back edge of the Tall End Filler to the wall and oor. If
needed, install Filler between a Wall Cabinet and the Tall
End Filler. After one Tall End Filler is installed, install the 24"
Deep Wall Cabinet according to the Deep Wall Cabinet
requirements.
Install the Tall End Filler for the opposite side, if applicable.
Toekick Platform with 96" Tall Cabinets
The Toekick Platform is shipped unattached on 96" Tall cabinets.
If the ceiling height is enough so the 96" high Tall cabinet can be
tipped up with the Toekick Platform installed, then you should
install the Toekick Platform before attaching the cabinet to the
wall.
The Platform is narrower than the cabinet and can be mounted
at the center, right, or left. This provides for Toekick space on the
sides when the cabinets are end-mounted. Lay the cabinet on
its back. Position the Toekick Platform to the back of the cabinet
and to the left, right, or center of the cabinet width.
Drill pilot holes through the corner gussets and into the wood
cleats in the bottom of the cabinet. Fasten the platform to the
bottom of the cabinet with the appropriate length wood screws
(not provided).
Set the cabinet upright and install according to the Attachment
to Wall requirements for Tall cabinets.
If the ceiling height does not permit installing the Toekick Platform
to the cabinet before installation, then install and level the Toekick Platform rst.
Position the Toekick Platform on the oor. Shim and level following the same procedure for installing a Base
Cabinet. The top of the Toekick Platform should match the height of the bottom edge of the Base cabinet
Face Frame. Mark wall stud locations and predrill according to the Attachment to Wall requirements for
Tall cabinets.
Carefully lift and slide the cabinet onto the Toekick Platform. Attach to the wall following the Attachment to
Wall requirements for Tall cabinets.
ToekickBase
PositionedRight
ToekickBase
PositionedCennter
ToekickBase
PositionedLeft
Tall Cabinet Face Frame
Wood Cleats
Toekick Platform
Corner Gussets