Installation Guide

7 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Installation - New Construction (continued)
5
Removing the wiring cover on the fan
housing
□ Remove the wiring cover (1). Pull the house wires through
the wire box cover hole. Using the quick connector, secure
120 V AC house wiring from the wall switch to the fan as
shown in the wiring diagram on page 3. 14 AWG is the
smallest conductor that should be used for branch circuit
wiring.
□ Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (1).
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult an
electrical contractor to determine safely.
House
wires
1
Quick
connector
Product
wires
6
Connecting the duct
□ Connect a 4 in. circular duct (not supplied) and vent to the
outside. Secure it with duct tape (not supplied) or a clamp
(not supplied) to make the connection secure and air tight.
□ Turn on the power source. Check the fan for any abnormal
sound or vibration.
7
Installing the grille
□ Use the spring clips to pinch mount and insert the grille (B)
into the narrow rectangular slots inside of the fan housing
(A) next to the fan motor.
A
B