Instructions / Assembly

3 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Warranty
If this product fails due to a defect in materials or workmanship at any time during the first three years of ownership, the manufacturer will
replace it free of charge, postage-paid at their option. This warranty does not cover products which have been abused, altered, damaged,
misused, cut or worn. This warranty does not cover use in commercial applications. The manufacturer DISCLAIMS all other implied or
express warranties including all warranties of merchantability and/or fitness for a particular purpose. As some states do not allow
exclusions or limitations on an implied warranty, the above exclusions and limitations may not apply. This warranty gives you specific legal
rights, and you may have other rights that vary from state to state.
This warranty is limited to the replacement of defective parts only. Labor charges and/or damage incurred during installation, repair,
replacement as well as incidental and consequential damages connected with the above are excluded. Any damage to this product as a
result of neglect, misuse, accident, improper installation or use other than the purpose SHALL VOID THIS WARRANTY.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
Pre-installation
PLANNING INSTALLATION
When installing the ventilation fan in a new construction site, install the main body of the fan and duct work during the rough‑in
construction of the building. The grill should be installed after the finished ceiling is in place.
When installing in existing construction, use the dimensions on page 12 to determine the required hole size for the ceiling. The grill edges
should overlap the finished ceiling.
NOTE: If installing in existing construction, you must
have access to space above and below the installation
location.
This unit will operate most quietly and efficiently when located where the shortest possible duct run and minimum number of elbows will be
needed.
Do not install the ventilation fan in areas where the duct work will require configurations as shown in the following figure: