Instructions / Assembly

www.hamptonbay.com
9 Please contact 1-877-527-0313 for further assistance.
Installation (continued)
6
Using quick connect
7
Connecting wiring from unit to
house
WARNING: Wiring must comply with all applicable electrical
codes. Turn OFF power before removing or installing
connectors.
WARNING: COPPER TO COPPER ONLY. Do not use on
Aluminum wire.
CAUTION: Accessory part AA (quick connect) should meet
installation instructions below.
NOTE: Connector is reusable on solid wires of the same wire
gage or smaller. Do not reuse connector on stranded wires.
□ Strip the wires so half of the bare wire is showing.
□ Grip the wire firmly and push the stripped end of
the wire into the open port of connector (AA). Use
only one stripped end of the wire per port.
□ Verify the stripped end of the wire is fully inserted
to the back of the connector (AA).
NOTE: Important wire information. Maximum temperature
rating 105°C (221°F). 600 volts maximum for building wire
and 1000 volts maximum in signs and lighting fixtures.
Flammability rating of the wires must meet UL94-V2. The
acceptable wire range includes: Solid: 12-20 AWG,
Stranded: 12-16 AWG (≤19 STRAND); 18AWG (7 STRAND),
Tin bonded: 14-18 AWG (≤19 STRAND).
WARNING: Make sure that the main power is off.
WARNING: Failure to wire this product correctly could result
in electrical shock, fire hazards, or damage to the product.
Consult a licensed electrician if you are unsure of your ability
to correctly install wiring.
CAUTION: If your house wires do not match these colors,
determine what each house wire represents before
connecting. You may need to consult a licensed electrician to
determine this safely.
□ Connect wires using the quick connector (AA) or
wire nut (not provided).
□ Connect the green (or bare) ground wire to the
green ground lead.
□ Connect the black wire from the unit to the black
house 120V AC line.
□ Connect the white wire from the unit to the white
house 120V AC line.
□ Connect the red wire of the Night Light to the black
house 120V AC line.
□ Replace the junction box cover. Do not pinch the
lead wires.