Installation Guide

Once the corner cabinet is in desired location referencing pull dimensions listed above or directly in the corner for a diagonal
cabinet. Secure the unit to the wall through the cabinet backing by using 10 X 2-½” washer head cabinet box installation
screws (not included) until they are nearly tight. Note: to ensure a correct alignment between cabinets, do not tighten any
hardware until all other cabinets have been installed. Install the adjustable shelves at the desired height using the provided shelf
pins.
Una vez que el gabinete de esquina estén en la ubicación deseada, según las dimensiones de tirador indicadas antes o por colocación directa en la
esquina de un gabinete diagonal. Asegure el gabinete a la pared a través de su respaldo usando los tornillos de 10 X 2-½” (no incluidos) de cabeza de
arandela que se usan para instalar cajas de gabinete, hasta que queden casi ajustados. Nota: para garantizar una alineación correcta entre los gabinetes,
no ajustes ningún herraje hasta que todos aquellos hayan sido instalados. Instala las repisas ajustables a la altura deseada usando los pasadores de
repisa incluidos.
STEP 5
Installing adjacent wall cabinets. Continue with the wall box installation by placing the next cabinet on the wall hanging rail.
Be careful to line up the bottom horizontal edges. Fasten the two cabinets together using clamps and clamp the cabinet sides
firmly. Be sure the adjoining cabinets are flush and level with each other. Use 1" wood screws (not included) to attach the
cabinets together. Fasten the adjoining cabinets to the wall as previously mentioned in step 5. Continue installing the remainder
wall cabinets in the same manner.
PASO 5
Cómo instalar los gabinetes de pared adyacentes. Continua con la instalación de caja de pared colocando el siguiente gabinete en el riel para colgar.
Ten cuidado de alinear los bordes horizontales inferiores. Sujeta los dos gabinetes juntos con prensas y firmemente por ambos lados. Asegúrate de que
los gabinetes contiguos queden al ras y nivelados entre sí. Usa tornillos de madera de 1 plg (no incluidos) para unir los gabinetes. Sujeta los gabinetes
contiguos a la pared como se indicó antes en el paso 5. Continúa instalando de la misma manera los gabinetes de pared restantes .
2
1
2
horizontal line
línea horizontal
wall studs
barrotes
1
blind wall
filler
relleno
Z
Y
X
adjacent wall
pared adyacente
3