Installation Guide

5 HAMPTONBAY.com
Please contact 1-800-841-1350 for further assistance.
Installation (continued)
3
Connect the wires
□ Connect the black and white wires of the
xture with two wires of the same colors from
the junction box. Secure together using wire
nuts (AA).
□ Connect the grounding wire of the xture with
the one from the junction box. Secure together
using a wire nut (AA).
4
Mount the housing
□ Align the keyholes on the housing (A) with the
mounting screws (BB). Then rotate the housing
to securely t to the junction box and tighten
screws to secure.
5
Install the shade
□ Align the slots on the shade (B) with the buckle
point on the inside of the housing (A).
Turn the shade (B) clockwise carefully and
conrm it locks into place.
6
Turn on the light
□ Restore power to the junction box. Turn the light
switch on to activate the xture.
□ Note: The Main light will not provide light output
while in night light mode.
·To return to main light mode after using night light
mode, switch the wall switch off then back on
again within 2 seconds.
□ Selecting Main Light or Night Light Mode
·To turn on the main light mode, switch on the
wall switch.
·To change to night light mode, turn on the main
light, then switch the wall switch off then back on
again within 2 seconds.
AA
B
BB
AA
A
A
SOFT WHITE
(
3000K
)
NEUTRAL WHITE
(
3500K
)
BRIGHT WHITE
(
4000K
)
DAYLIGHT
(
5000K
)
WARM WHITE
(
2700K
)
CAUTION: With the small space inside junction box for
electrical wiring. Check wiring to make sure it is not cut or
damaged which can cause an electrical short.