Instructions / Assembly

2
Table of Contents
Safety Information
Warranty
CAUTION: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have resulted during
shipping. If there is a defect in the wire, do not attempt
installation. Please call our Customer Service Team at
1-855-HD-HAMPTON.
CAUTION: Use only on 120 volt 60Hz circuits. Not for use
where directly exposed to the weather. Starting temperature
-20˚F. Optimum operating temperature -10˚F to 140˚F. This
device is not intended for use with emergency exit fixtures or
emergency exit lights. Do not use with dimmers, photocon-
trols or electronic timers. Never use more than 25 lamps per
20 amp branch circuit.
CAUTION: Suitable for damp locations. Not for use
with dimmers.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from
date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If
this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the
product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modifica-
tions, alterations, neglect, or mishandling. This warranty shall not apply to any product that is found to have been improperly installed,
set-up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of
the product as a result of an accident, misuse, abuse, negligence, alteration, faulty installation, or any other
failure not relating to faulty
material or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as
this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or
implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability
and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labor / expense costs involved
in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
..........................................................2
...................................................................3
Table of Contents
Package Contents
.........................................................2Safety Information
.................................................................... 4 Assembly
.........................................................................2Warranty
....................................................................... 5Operation
................................................................3 Pre-Assembly
........................................................ 5Care and Cleaning
........................................................ 3 Planning Assembly
............................................................ 5Troubleshooting
WARNING: Before starting installation of this fixture or
removal of a previous fixture, disconnect the power by
turning off the circuit breaker or by removing the fuse at the
fuse box.
 Consult a qualified electrician if you have any electrical questions.
 NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.