Installation Guide

Assembly (continued)
Attaching the main canopy and
vent cover
5
Cover the roof with the main canopy (M). Fully extend each
corner of the main canopy (M) and insert the end of each roof
tube (E) into the canopy pockets.
From inside of the frame place the vent cover (L) over the frame.
Fully extend each corner of the vent cover (L) and insert the end
of each corner roof tube (D) into the pockets of the vent.
□
□
□
Adjust each post until all posts stand upright. Make sure all are
level.
□
Hammer one ground stake (FF) through the hole in the
bottom of each panel (A and B) board into soft ground to
stabilize the gazebo.
7
Attaching the mosquito netting to
the gazebo
6
Attach the mosquito netting (N) to the corner first, then to the
lintel tubes (H and I) with velcro. The netting should be insde
of the gazebo.
□
NOTE
:
There are four velcro pieces on the 10 ft. side and ten
velcro pieces on the 12 ft. side.
L
M
F
B
F
A
N
HAMPTONBAY.COM
Please contact 1-855-HD-HAMTPON for further assistance.
NOTE
:
The nettings have already been zipped from four
to
two pieces
in the packaging.