Instructions / Assembly

36 | Installation How-Tos Installation How-Tos | 37
Wall Microwave Shelf
Transfer measurements for the location of the electrical outlet onto the
back of the Wall Microwave Shelf. Cut the hole in the cabinet back to
accommodate the outlet box. If no outlet exists, check your microwave
oven manufacturer’s recommendation.
Install the cabinet following the Installation Requirements. Once the
cabinet is mounted, slide the cabinet shelf (shipped not installed) into
the cabinet with the pilot holes facing down. Attach the shelf to the
cabinet using the (6) #8 x 1-1/4" screws with washers provided with
cabinet.
WARNING! Use the washers to ensure the screw heads will not
pull through the bottom of the cabinet.
Desk Knee Drawer
The width of the Knee Drawer Trimmable can be trimmed up to 3"
on each side. Must be attached on both sides to an adjacent cabinet
face frame, wall, or Desk End Panel.
Transfer wall stud locations onto back panel, shim, and pre-drill to
attach to wall. Position the Desk End Panel even with the top of, and
just behind the Drawer frame, clamp to Drawer side panel, pre-drill
through the Drawer side panel in (4) places with a 1/8" drill bit, 1"
deep.
DO NOT drill through the Desk End Panel. Fasten Desk End Panel to side panel with #8 x 1" pan head
screws (not provided). Firmly seat the head of the wall attachment screw against the back of 36" wide Tall
cabinets so as to prevent the back joint from breaking.
Six (6) pilot holes
on bottom of shelf
Six (6) No. 6x 1-1/4”
Screws and Washers
(View from below)
Cut 3” Off
Desk Leg
For Vanity
Depth
Desk
LEG
APRON
DRAWER
CLAMP
INSTALLATION
SCREW
SHIM
3/4” WOOD
Conversion of Vanity Drawers to False
Front (continued)
Lay the Drawer Front face down on a protected surface. Drill
a 3/32" diameter 1/2" deep hole as shown. For traditional
overlay door styles, the hole is located 2-3/4" from the bottom
of the drawer front and 15/16" from the side of the drawer
front. For full overlay door styles, the hole is located 2-3/4"
from the bottom of the drawer front and 1-5/8" from the side
of the drawer front. Repeat on both sides.
Install the (2) metal clips in the pre-drilled holes on the back
side of the drawer front using the provided screws. Snap the
Drawer Front onto the drawer opening.
METAL VENT
CLIP
#5 X 5/8 FLAT
HEAD SCREW
BACK SIDE OF
DRAWER VENT
2 3/4˝
TRADITIONAL OVERLAY 15/16˝
FULL OVERLAY 1-5/8˝