Manualshelf

Instructions / Assembly

ManualsBrandsHampton Bay ManualsAssembled Kitchen CabinetsCourtland Shaker Assembled 24 in. x 34.5 in. x 24 in. Stock Drawer Base Kitchen Cabinet in Polar White
11121314151617181920
38 | Installation How-Tos Installation How-Tos | 39
Toekick Covers
Measure the length of the toekick area and cut the Toekick Cover to that length. Clean the area of any
debris. Apply glue to the back of the Toekick Cover and place onto the toekick area. Use small nishing
nails to tack the Toekick Cover in place.
Hardware
Drill 11/64" holes from the front side of the door for decorative hardware. It is recommended
to apply masking tape on both sides of the door stile and drawer assemblies in order to
reduce tear out when drilling. This is also benecial for marking the drilling hole location.
It is recommended on Full Overlay door styles to keep the door ajar when drilling through the
stile so the drill bit does not strike the cabinet frame.
Countersinking the hardware screws to the proper depth will prevent the screw heads from
striking the cabinet frames during normal operation.
INSTALLER NOTE: Some door styles may have holes on the back that were used in
the nishing process. These should not be used as pilot holes to mount the hardware.
6-way Hinge Adjustments (continued)
6-way Hinge Adjustments
A. Up and down adjustment ….….…. +/- 2.0mm. Loosen Screw A, align door, tighten Screw A.
DO NOT overtighten Screw A.
B. Left or Right adjustment ………….. +/- 1.5mm. Turn Screw B clockwise or counterclockwise.
C. In or Out adjustment ………………. -.5 / +2.5mm. Turn Screw C clockwise or counterclockwise.
Undermount Guide - Drawer Removal and Adjustment
To remove drawer, open the drawer and squeeze the orange handles of both locking devices. While
holding the handles, pull the drawer straight out and lift it off the guide runners.
To install drawer, place drawer on the guide runners (either extended or retracted) and close the drawer.
The locking devices will automatically engage with the guide runners. Open the drawer completely to
conrm that both locking devices have engaged.
To adjust the drawer height, open the drawer and press down on either or both adjustment lever(s). Slide
the lever(s) toward the front of the drawer to lower the drawer and toward the front of the drawer to raise
the drawer.
Screw B
Screw A
Screw C
Screw B
Screw A
Screw C
ScrewA
ScrewB
ScrewC
Screw A
Up and Down
Screw B
Left or Right
Screw C
In and Out
RIGHT
WRONG