Instructions / Assembly

Page 9
Possible Cause Corrective Action
1. Power is off. 1. Make sure power supply is on.
2. Faulty switch. 2. Test or replace switch.
3. Faulty wire connection. 3. Check wiring.
4. Damaged or defective driver. 3. Replace the driver.
Fuse blows or circuit
breaker trips when light is
turned on.
1. Crossed wires or power wire is
grounding out.
1. Check wire connections.
Light will not turn on.
TROUBLESHOOTING:
PRODUCT MAINTENANCE:
1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth
(use clean water, never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by
turning off the circuit breaker or by removing the fuse at the fuse box. Next,
use a dry or slightly dampened clean cloth (use clean water, never a solvent)
to wipe the interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only
a dry soft cloth to dust or wipe carefully.
DRIVER REPLACEMENT:
This product is ENERGY STAR® listed. The driver can be replaced without
having to cut wires. Please contact a qualified electrician if driver replacement is
needed.
Page 9
CDL
JWM040W-0700-56
Dimmable Constant Current LED Driver
Max case temperature tc = 90°C
Class II
Suitable for operation with a TRIAC dimmer
Suitable for dry or damp locations
AC INPUT:
120/277 V – 0.66 A
50/60 Hz
PF≥0.9
THD ≤20%
L-BLACK
N-WHITE
SELV
DC OUTPUT:
Regulated current 700 mA
Maximum power 39.2 W
Voltage range 2856 Vdc
No load voltage 60Vdc
+ RED
- BLACK
+ DIM: PURPLE
- DIM: GREY
(For 0-10V dimming)
This Class [B] RFID complies with
the Canadian standard ICES-005.
Made in China
LVLE
100