Use and Care Manual

7. Please make sure that the grounding bar is properly grounded and attached/clipped to the
side of the recessed housing wall.
8. Install your new ceiling mounted fixture. Note: All models are not shown in the diagrams.
CAUTION: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSON(s), do not
install any fixture that exceeds the maximum wattage of the adapter of 660 watts or the
maximum weight capacity of 35 lbs.
9. Restore electricity and check the operation of your new lighting fixture.
READ AND SAVE THESE INSTRUCTION
TROUBLE SHOOTING:
PRODUCT MAINTENANCE:
1. To clean the fixture, first disconnect power to the fixture by turning off the circuit breaker
or by removing the fuse at the fuse box.
2. Use a dry or slightly dampened clean cloth (use clean water, never use a solvent) to wipe
the interior and exterior surfaces of the fixture.
3. Allow the fixture to dry thoroughly before power is restored.
CAUTION: Do not use chemical solvents or harsh abrasives to clean fixture as damage to the
fixture or various components may occur remedying the fixture inoperable.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of five (5) years from date of purchase. This warranty applies only to
the original consumer purchaser and only to products used in normal use and service. If this
product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy,
is the repair or replacement of the product at the manufacturer’s discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations,
neglect or mishandling. This warranty shall not apply to any product that is found to have been
improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not
relating to faulty material or workmanship. This warranty shall not apply to the finish on any
portion of the product, such as surface and/or weathering, as this is considered normal wear and
tear. The manufacturer does not warrant and specially disclaims any warranty, whether express
or implied, of fitness for a particular purpose, other than the warranty contained herein. The
manufacturer specifically disclaims any liability and shall not be liable for any consequential or
incidental loss or damage, including but not limited to any labor/expense costs involved in the
replacement or repair of said product.
Problem Possible Cause Corrective Action
1. Light bulb is burned out. 1. Replace light bulb.
2. Power is off. 2. Make sure power supply is on.
3. Faulty wire connection. 3. Check wiring.
Light Bulb will not
illuminate.
4. Faulty switch. 4. Test or replace switch.
Fuse blows or circuit
breaker trips when light
bulb is illuminated.
Crossed wires or power
wire is grounding out.
Check wire connections.