Use and Care Manual

8 a.m. - 6 p.m., EST, Monday - Friday
1-877-527-0313
USE AND CARE GUIDE
3-PACK CABINET LIGHT KIT
Installation
Installation
Installation
5
Installing the wire clips
6
Installing multiple units
Part Description
A Glass UV lens [preassembled to lens cover (B)]
B
C
D
Fixture body & Socket [preassembled to plastic housing (E)]
E
Plastic housing
F
H
G
Extension cord
1. The bulb becomes hot quickly. Only contact the
switch/plug when turning the light on.
IMPORTANT SAFETY INSTRUCTIONS
(Save These Instructions)
2. Do not touch hot lens, guard, or enclosure.
3. Do not remain in the light if skin feels warm.
4. Do not look directly at a lit bulb.
5. Use only with a 20 watt G8 Xenon bulb.
7. Use only insulated staples or plastic ties to
secure cords.
8. Route and secure cords so that they will not be
concealed, pinched or damaged.
The lit lamp is hot!
Troubleshooting
There is a bad wire connection.
The light bulb is burned out.
Problem
Possible Cause
Solution
does not work.
There is a faulty switch.
The power is off.
Replace the bulb.
Check the wire connections.
Test or replace the switch.
TOOLS REQUIRED
Safety
goggles
Scissors
Phillips
screwdriver
Drill
Hammer
Hole saw
Pencil
Hardware not shown to actual size.
HARDWARE INCLUDED
BB -
Long mounting
screw x 9
DD -
Short mounting
screw x 6
AA -
Wire clip
x 6
CC -
Rubber
gasket x 3
EE -
Mounting
bracket x 3
FF -
Switch
x 1
GG -
Switch
holder x 1
HH -
Switch
mounting
screw x 1
A
B
C
E
D
F
G
H
3
2
Installing on a surface mount
Installing on a recessed mount
4
Installing the quick connector plug
(optional)
1
Unscrew and remove the switch cover (FF).
With scissor s, separate the neutral wire (1)
(parallel ridge) from the hot wire (2)
(smooth with printed words) of the extension cord (H).
Cut the hot wire (2) and push in to connect both wire ends.
Route the neutral wire (1) through the switch housing.
Apply force to the hot wires (2) to make sure the conductive
sharp points pierce the wire insulation.
Replace and secure the switch cover (FF) with a screwdriver.
Install the switch holder (GG) (optional) to a convenient and
accessible location with the screw (HH) provided.
Secure the switch into the holder.
D
B
1
2
F
1
F
G
F
H
B
C
Remove the bulb (C) by pulling straight out
in a horizontal direction.
Insert the new bulb (not included) into the
cloth. (Oil from the skin may damage bulb.)
Questions, problems, missing parts? Before returning to store,
HOMEDEPOT.COM
This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric
can be fully inserted. Do not alter the plug in any way as serious injury or damage may result.
Safety Information
The National Electrical Code
(NEC) does not permit cords to be concealed
where damage to insulation may go unnoticed.
where it may be inaccessible for examination.
The cord should be visually examined
periodically and immediately replaced
when any damage is noted.
6. Do not operate the unit with a missing or damaged
Contact the Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
light kit. We strive to continually create quality products designed to enhance your home. Visit us online to see our full
line of products available for your home improvement needs. Thank you for choosing Commercial Electric!
THANK YOU
Warranty
PACKAGE CONTENTS
(AA) and secure to the wood cabinet
with a hammer (not included).
Wire clips (AA) are provided to secure the
standard outlet or the extension cord (H).
body (D) by turning counterclockwise.
body (D) by turning counterclockwise.
location under the wood cabinet with the
three long mounting screws (BB).
body (D).
body (D) by turning counterclockwise.
housing (E).
Install the rubber gasket (CC) to the underside of
Drill a 2 3/8 in. hole into the desired location in
the wood cabinet.
Install the mounting bracket (EE) with short
mounting screws (DD).
length if necessary. This helps to minimize the
amount of wire underneath the cabinets.
Remove the plug cover (1) from the plug (G).
to the right (neutral side) down and into the
front of the plug (G).
prongs.
Slide the plug cover (1) back onto the plug over
Care and Cleaning
occur.
Do not touch a new or existing light bulb with bare hands. Oil from skin will damage the bulb and
shorten the life of the bulb.
Bulb replacement: Use 20 watt, 120 volt, G8 Xenon or Halogen bulb.
the quick connector plug.
10. Not intended for recessed installation in ceilings,
Neutral Wire (1)
Hot Wire (2)
Check that the power supply is on and
check the circuit breakers.
11. This cabinet light is not intended for installation
in plastic cabinets.
9. Do not run the Line-Voltage power supply cord
Pre-Installation
The quick connector plug may
not be properly installed.
D
call Commerial Electric Customer Service
Pre-Installation
Do not install this lighting
system in a wet location.
Turn off/unplug the light
and allow it to cool before replacing
the bulb.
Keep the lamp away from
materials that may burn.
Do not touch the bulb at
any time. Use a soft cloth. Oil from skin
may damage the lamp.
H
FF
GG
HH
AA
BB
E
D
B
2 3/8 in.
D
F
B
1
2
3
4
DD
EE
DD
EE
CC
CC
Qty.
3
3
3
3
3
3
3
1
7
Item #148-407, 148-652
Model #EC5930BK-XC, EC5930WH-XC
To reduce the risk of FIRE, ELECTRIC
SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION, OR
INJURY TO PERSONS:
Installing the optional switch
use only with wire type SPT-2.
CAUTION:
WARNING:
WARNING:
WARNING:
CAUTION:
CAUTION:
CAUTION:
CAUTION:
NOTE:
NOTE:
12. This cabinet light is not intended for installation
inside enclosed furnishings such as: aquariums
kitchen cabinets, china cabinets, or trophy cases.
year from the date of purchase. If within this period the product is found to be defective in material
or workmanship, the product must be returned, with a copy of the bill of sale as proof of purchase, to the
original place of purchase. The manufacturer will, at its option, repair, replace or refund the purchase price
excludes liability for direct, incidental or consequential damages. As some states do not allow exclusions
or limitations on an implied warranty, the above exclusions and limitations may not apply. This warranty