Use and Care Manual
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly and Installation
1
ATTACHING AND INSTALLING THE LIGHT
WARNING: Never push the xture into the ground by the lamp body
(A) or use a hammer to insert the ground stake (B) into the ground.
□ Insert the lamp post (D) into the body of the lamp (A) and
secure it with a screw (E).
□ Insert the wire with the quick connector (C) into the groove
located on the top of the ground stake (B).
□ Lock the ground stake (B) on the lamp post (D) with a
screw (G).
□ Prepare a hole in the installation location. Use a tool such as
a screwdriver to prepare the installation hole to ensure that
the hole is not larger than the ground stake (B).
□ Install the xture in the ground by pushing on the foot step (1)
on the ground stake (B). Do not push on the lamp body (A).
E
1
A
D
C
B
F
G
2
CONNECTING THE WIRES
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from the low voltage power unit should be
SPT-2W 14-18 AWG type underground low Energy Circuit Cable. The
minimum length is 50 ft.
IMPORTANT: Protect the wiring by routing it in close proximity to
the light tting, or next to a building structure such as a house or a
deck. The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in. (15.24 cm).
Do not install the xture within 10 ft. of a pool, spa, or fountain. Do not
submerge the xture in water.
□ Place the wire connector (C) on opposite sides of the low
voltage cable (not included) from the transformer (not
included) where the xture will be located.
□ Align and t the main low voltage cable vertically to the slot
of the wire connector (C).
□ Press the wire connector (C) together until it is locked
around the main low voltage cable. The pre-set prongs will
pierce the cable insulation and establish contact with the
electrical wire inside.
□ Once the wire connector (C) is in place, it is recommended to
wrap it with electrical tape (not included).
□ After all xtures are installed, turn on the transformer.
C
C
Use and Care Guide
Low Voltage LED Landscape Light
Item #1000 000 000
Model #ECP16-LED
PACKAGE CONTENTS
A - Lamp body
x 1
B - Ground stake
x 1
C - Quick connector
x 1
D - Lamp post
x 1
E - Screw
x 1
F - Hexagon wrench
x 1
G - Screw
x 4