Installation Guide

Page 19
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2.
CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE
QUESTION RELATIVE A L'ELECTRICITE.
3.
La luminosité des ampoules électriques fluorescentes compactes GU-24
fournies avec ce luminaire n’est pas modulable. Ne pas utiliser de dispositif
de modulation de luminosité avec ce luminaire.
4.
En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com. Veuillez indiquer votre
UGS
(714-316
luminaire blanc
, 714-250
luminaire nickel brossé
, 720-163 luminaire bronze
huilé) ou UPC (6940500313412
luminaire blanc
, 6940500313405
luminaire
nickel brossé
, 6940500313429 luminaire bronze huilé).
5.
Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
Ampoule (inclus) Lunettes de Protection Echelle Gants Dénudeur de câbles électriques
(13 watts maxima)
Tournevis à tête plate Tournevis à croisillon Ruban adhésif isolant Pince pour câbles électriques
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#12) 2ea Outlet Box Screws (#13) 1ea Mounting Strap (#14)
1ea Ground Screw (#15) 2ea Mounting Screws (#16)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#16) into the Mounting Strap (#14). Mount the
Mounting Strap (#14) to the Outlet Box (#11) using the two Outlet Box Screws (#13).
[Make sure the heads of the Mounting Screws (#16) are facing outside when the
Mounting Strap (#14) is attached to the Outlet Box (#11).]
2. Wrap the ground wire from the fixture around the Ground Screw (#15) on the Mounting
Strap (#14), and then connect the ground wire from the fixture to the ground wire from
the Outlet Box (#11). Connect the white wire from the fixture to the white wire (neutral
wire) from the Outlet Box (#11). Connect the black wire from the fixture to the black
wire (live wire) from the Outlet Box (#11). Cover the three connections using the three
Wire Connectors (#12). Wrap the three wire connections with electrical tape for a more
secure connection. Position the wires back inside the Outlet Box (#11). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the Canopy (#1) over the Outlet Box (#11). Allow the heads of the Mounting
Screws (#16) to come out through the large ends of the keyholes on the Canopy (#1).
Twist the Canopy (#1) clockwise until the heads of the Mounting Screws (#16) slide into
the narrow ends of the keyholes. Tighten the Mounting Screws (#16) to secure the
Canopy (#1).
4. Before completing Installation, please return to Assembly Instruction #4.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.