Use and Care Manual

Assembly and Installation
1. Insert Fixture Cable into decorative pipe(s) (11, 12, 13 and 14) as needed to create the desired
total length. Next, fasten the bottom section of pipe to the lamp cup (15). Then attach canopy (9)
to top section of pipe.
2. Make sure all the electrical is power off, and then attach the mounting plate (7) to the junction
box (1) with the provided machine screws (6).
3. Wrap the ground wire (3) under and around the ground screw (5) which marked “GND”, and
fasten the ground screw (5) to make sure the ground wire (3) is securely connected. Connect
black/smooth fixture wire to black supply wire and white/ribbed fixture wire to the white supply
wire using wire connectors provided. Connect the fixture ground wire and the house ground wire.
Place wiring back in junction box.
4. Place the canopy (9) to
t
t
h
h
e
e
j
j
u
u
n
n
c
c
t
t
i
i
o
o
n
n
b
b
o
o
x
x
u
u
s
s
i
i
n
n
g
g the 2 mounting screws (8) and attach to ceiling by
tightening the decorative nuts (10).
5. Place the shade (16) onto the socket (15) and secure by tightening the socket ring (17).
6. Install bulb.
ELECTRICAL CONNECTIONS
Required Supply Circuit: 120V, 60Hz
Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the black wire(s)
from the fixture to the black wire of the supply circuit. Connect the green or bare copper wire to the ground
wire of the supply circuit. Use UL/CSA listed wire connectors suitable for the size type, and number of
conductors. No loose strands or loose wires should be present. Secure wire connectors with UL/CSA listed
electrical tape.