Installation Guide

8
Clearance to Combustibles
Sides 4 in. (101.6 mm)
Floor 0 in. (0 mm)
Top 36 in. (914 mm)
Front 36 in. (914 mm)
Rear 0 in. (0 mm)
□ Out of direct sunlight
□ Not susceptible to moisture
□ Away from uninsulated outside wall
The stove should be located in an area:
ASSEMBLY INSTRUCTIONS
1. Lay the stove (A) upside down on a padded surface with the underside accessible. Attach the leg (B) to the stove by inserting the tab
on the top of each leg (B) into the corresponding slot on the bottom of the stove (A). Insert three screws (C) into predrilled holes and
tighten securely for each leg (B).
2. Carefully position the stove against a wall.
3. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum of 1,875 watts if necessary.
CAUTION
Make sure that the unit is installed so that the power cord is not compressed against or caught on the stove and that it has an unobstructed path to the grounded outlet.
WARNING
The stove is heavy and should be assembled near its
desired location.
It is recommended that two people move the assembled
stove to prevent injury.
Installation
□
□
WARNING
Do not install the unit on shelves, raised platforms, beds, blankets, pillows etc. Keep combustible materials such as furniture, bedding,
papers, clothes and curtains at least 3 ft. (914 mm) from the stove.
SLOT
A