Installation Guide

WALL FIXTURE

Instruction Manual

Please read carefully and save these instructions, as you may need them at a later date.

SAFETY

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER

THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF

USING THE LIGHT SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK.

NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all

possible conditions or situations that may occur. It must be understood that common sense, caution,

and care, are factors which cannot be built into any product. These factors must be supplied by the

person(s) installing this unit.

READ & SAVE THESE INSTRUCTIONS

CAUTION: Before assembling the lighting fixture, refer to the section titled Wiring Connections. If you

feel you do not have enough electrical wiring experience, either refer to a do-it–yourself wiring

handbook or have your lighting fixture installed by a qualified, licensed electrician.

UNPACK THE PACKAGE

Check the contents to be sure everything is included

Tools Needed: Slotted screwdriver, Adjustable wrench, Step ladder, Wire cutters, Wiring supplies as

required by electrical code.

INSTALLATION & OPERATION INSTRUCTIONS

GENERAL

Before starting the installation, disconnect the power by turning off the circuit breaker or by removing

the appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to

prevent electrical shock.

All electrical connections must be in accordance with local and National Electrical Code (NEC)

standards. If you are unfamiliar with proper electrical wiring connections, obtain the services of a

qualified electrician.

Remove the fixture and the mounting packages from the box and make sure that no parts are missing

by referencing the illustrations on the installation instructions.

Be sure to read these installation instructions and review the diagrams thoroughly before installation.

PAGE 1
WALL FIXTURE Instruction Manual Please read carefully and save these instructions, as you may need them at a later date. SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF USING THE LIGHT SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK.
PAGE 2
Assembly and Installation 1. Secure the mounting plate (5) to the outlet box (1) using the screws (6) provided. 2. Wiring Connections: Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the black wire(s) from the fixture to the black wire of the supply circuit. Connect the green or bare copper wire to the ground wire of the supply circuit. Use UL/CSA listed wire connectors suitable for the size type, and number of conductors.