Instructions / Assembly

BATTERY IS NOT INCLUDED.
15 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Operation – Battery Installation and Lighting the Fire Pit
1
Battery Installation
2
Lighting Instruction
□ Make sure the control knob is in the “OFF” position.
□ Unscrew the push button cap on the igniter module located on
the control panel to access the battery compartment.
□ The igniter module requires one AAA size battery.
WARNING:
1. Please observe proper polarity and use the correct
battery type when placing or replacing the battery.
Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is
to be left unused for a long period of time.
□ Push in the gas control knob slightly and turn to “OFF”.
□ Turn the gas control knob to the “ON/MIN”.
□ Push in the gas control knob all the way in and hold. Continue to
press the ignition button for 15 seconds.
□ If the burner does not light in 15 seconds, release the knob and
it will pop back out. Wait 5 minutes before attempting to light
the burner again. Repeat the above process.
□ O
bserve Flame Height When Lit. The burner will display blue and
yellow flames. These flames should be a blue / yellow color
between 1~2 in. height . These flames should not be yellow or
produce thick smoke. This would indicate an obstruction of
airflow through the burners. The flames should be blue with
straight yellow tops. If excessive yellow flames are detected, turn
off the burner and consult “Troubleshooting” on Page 16.
WARNING:
1. For your safety, read and follow the Lighting
Instructions in this manual and in the Rating Plate on
the appliance.
2. IMPROPER LIGHTING PROCEDURES COULD RESULT
IN A FIRE HAZARD OR EXPLOSION HAZARD OR
PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
Good Bad
Yellow
Yellow
Light Blue
Light Blue
Blue
Blue
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
2. Turn gas control knob the “ON/MIN”.
3. Push in gas control knob all the way
4. If the burner does not light in 15
1. Push in gas control knob slightly and turn to “OFF”.
TO TURN OFF GAS
INSTRUCCIONES DE ENCENDIDO
PARA CERRAR EL GAS
1. Presione ligeramente la perilla de control del gas y gírela a la
2. Gire la perilla de control del gas a “ENC/MÍN” (encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga presionada.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta
encender el quemador nuevamente, repita los pasos 1 al 3.
1. Presion ligeramente la perilla de control del gas y gírela a la
turn to “OFF”.
and hold. Continue to press the
ignition button for 15 seconds.
seconds, release the knob and it will
pop back out. Wait 5 minutes before attempting
to light the burner again, repeat step 1 to 3.
posición “APG” (apagado).
Siga presionando el botón de encendido durante 15 segundos.
volverá a su posición hacia afuera. Espere 5 minutos antes de intentar
posición “APG” (apagado)
OFF
(APG.)
MAX
(MÁX .)
1 AAA
1.5V
IGNITOR
( Encendedor )
ON/MIN
(ENC./MÍN.)